Setting Fence Stops - Grizzly G0834 Owner's Manual

Setting Fence Stops

The fence stops simplify the task of adjusting the
fence to 45˚ inward, 90˚, and 45˚ outward (135˚).
Items Needed
Open-End Wrench 14mm .................................. 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Setting 45° Inward
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen fence
block upward,
approximately 45° inward onto positive stop
bolt (see Figure 61).
Stop
Block
Figure 61. Fence set to 45° inward.
3. Place sliding bevel set to 45° inward against
fence and table, as shown in Figure 62.
Figure 62. Adjusting fence to 45° inward.
Model G0834 (Mfd. Since 12/17)
Qty
tilt lock, rotate stop
and position fence
Positive
Stop Bolt
(1 of 2)
Sliding
Bevel
4. Loosen jam nut on 45° inward positive stop
bolt and adjust stop bolt until fence is exactly
45° inward while resting on bolt .
5. Verify angle with sliding bevel set to 45°
inward, as shown in Figure 62, then retighten
jam nut.
Setting 45° Inward
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen fence tilt lock, rotate stop block down,
and position fence approximately 90° onto
positive stop bolt (see Figure 63).
Stop
Block
Figure 63. Adjusting fence to 90°.
3.
Place 90° square against fence and table.
4.
Loosen jam nut on 90° positive stop bolt
and adjust stop bolt until fence is exactly 90°
while resting on bolt.
5.
Verify angle with 90° square, as shown in
Figure 63, then retighten jam nut.
Positive
Stop Bolt
90°
Square
-43-