Table of Contents
Advertisement
8
Troubleshooting
About this chapter
This chapter provides information to assist users and service personnel to identify and
correct problems that may occur when operating the product.
If the suggested actions in this guide do not solve the problem, or if the problem is not
covered by this guide, contact your GE representative for advice.
In this chapter
Section
8.1 General problems
8.2 Problems with image quality
8.3 Problems with the software
General troubleshooting
procedure
Follow this procedure if an error occurs:
1 Take note of the error code and error message on the monitor.
2 Turn off the instrument by pressing the On/Off button on the front panel and then
3 If the error persists refer to this troubleshooting guide for possible solutions.
4 If the error cannot be resolved with this troubleshooting guide, contact your GE
Amersham Imager 680 Operating Instructions 29271308 AB
the Power switch on the right hand side, and turn it back on again after about ten
seconds.
representative.
8 Troubleshooting
See page
236
238
240
235
Advertisement
Table of Contents
