Turn On The Instrument - GE Amersham Imager 680 Operating Instructions Manual

5.2

Turn on the instrument

The following section describes the startup process.
Note:
Step
1
2
3
Amersham Imager 680 Operating Instructions 29271308 AB
If using a wired external monitor or touchscreen it must be connected to the
instrument before start up.
Action
Turn on power to the instrument by pressing the Power switch on the bottom
right side of the instrument to the I position.
Press the On/Off button on the front of the instrument to activate it.
Result: The instrument's self-diagnostic process will initialize.
Note:
The self-diagnostic process will normally take approximately 5 minutes.
Connection to a network may take longer.
If relevant, connect a USB flash drive to the instrument for file storage.
The USB flash driver is automatically installed when the USB flash drive is
connected to Amersham Imager 680.
Note:
Password protected USB flash drives are not supported.
5 Operation

5.2 Turn on the instrument

101