Save Locations - GE Amersham Imager 680 Operating Instructions Manual

5 Operation
5.7 Save and manage image files

5.7.1 Save locations

5.7.1 Save locations
Introduction
You can save files on several locations:
•
•
•
Connect a USB flash drive
A USB flash driver is automatically installed when the USB flash drive is connected to
Amersham Imager 680.
Note:
Add new save location
Follow the instructions to add a location for file saving.
Note:
Step
1
168
On the instrument
Note:
Amersham Imager 680 is equipped with a flash drive that allows for storage
of a finite number of images on the instrument. It is necessary to regularly
remove images from the instrument to ensure available storage space. If
the instrument flash drive runs full, the oldest images will automatically
be removed when a new image is captured.
Tip:
An external hard drive can be added to the USB port at the rear of the in-
strument to expand available storage capacity.
On an external USB flash drive
On a network drive
Note:
Network access is possible providing the instrument has been granted
access to the network location. For more details see Section 4.4 Network,
on page 89.
Password protected USB flash drives are not supported.
To enable access to a location for saving files over the network, the specific
folder must be shared and read/write privileges must be added for the
Amersham Imager 680 instrument. See Section 4.4 Network, on page 89.
Action
Select the settings icon in the top right hand corner of the screen:
Amersham Imager 680 Operating Instructions 29271308 AB