Light Kit Installation; Switch Housing - Honeywell 50202 Manual

To install the fan without a light kit, skip to Step 28.
22. Remove screws and washers from the switch
housing cap. Then connect the single pin
connectors from the switch housing to the single
pin connectors from the switch housing cap --
black to black and white to white. Ensure the plugs
connect tightly (Fig. 22).
Washer
Screw
23. Align the notch in the switch housing cap with
the reverse switch. Then lift the switch housing
cap and re-insert the three screws and washers
that were previously removed. Use a Phillips
screwdriver (not included) to secure the screws
(Fig. 23).
Washer
Screw
24. Install each bulb (Fig. 24).
Important: When replacing bulbs, allow bulbs and light
kit to cool before touching.

LIGHT KIT INSTALLATION

14
Fig. 22
Screw and
Washer Housing Cap
Fig. 23
Screw and
Washer
Notch
Fig. 24
Bulb
Switch
Reverse
Switch
Switch
Housing
Cap