Light Kit; Finial Cap; Finial - Honeywell 50202 Manual

25. Remove the pre-installed rubber washer, nut, finial
cap, and finial from the light kit (Fig. 25).
26. Feed pull chain through the center hole in the
glass globe, rubber washer and nut. Lift the glass
globe and rubber washer over the threaded rod.
Screw the nut onto the threaded rod to temporarily
hold the glass globe in place. Feed the pull chains
through both holes in the finial cap and the center
hole in the finial and lift the finial cap up until it is
flush with the glass globe. Screw the finial onto the
threaded rod to hole the light kit in place (Fig. 26).
27. The pull chain extensions or custom pull chains
extensions (sold separately) may be attached to
fan and light pull chains (Fig. 27).
Light Pull Chain
The installation is complete.
LIGHT KIT INSTALLATION
Fan Pull Chain
15
Fig. 25
Nut
Fig. 26
Rubber
Washer

Finial Cap

Fig. 27
Light
Pull Chain
Rubber
Washer
Finial Cap

Finial

Nut
Finial
Fan
Pull Chain