Honeywell 50202 Manual page 16

28. (Optional) To install the fan without a light kit:
Unscrew the nut located inside the switch housing
cap from the threaded rod in the center of the cap
to remove the light kit from the switch housing cap
(Fig. 28).
29. Align the notch in the switch housing cap with the
reverse switch. Then lift the switch housing cap
into the switch housing and re-insert the three
screws and washers that were previously removed.
Use a Phillips screwdriver (not included) to secure
all screws (Fig. 29).
Screw Washer
INSTALLATION WITHOUT LIGHT KIT
Fig. 28
Fig. 29
Screw
and
Washer
Switch Housing
Cap
16
Hex Nut
Light
Pull Chain
Switch
Housing
Cap
Light Kit
Reverse
Switch
Notch