Advertisement
Advertisement
Table of Contents
Related Manuals for Honeywell 50616
Summary of Contents for Honeywell 50616
- Page 1 Home Barcadero Ceiling Fan User Guide Model #50616, 51475, 51476, 51625...
-
Page 2: Package Contents
PACKAGE CONTENTS Canopy Canopy Cover Mounting Bracket Screw (x 4) Mounting Bracket Yoke Cover Downrod Downrod Pin Downrod Clip Set Screw (x 2) Motor Assembly Blade Arm (x 3) Fitter Plate Blade (x 3) Fitter Plate Screw (x 3) Light Pan Light Pan Screw (x 3) Light Kit Glass Bowl... -
Page 3: Safety Information
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. • Before you begin installing the fan, disconnect the power by removing fuses or turning off the circuit breakers. • Make sure all electrical connections comply with local codes, ordinances, the National Electrical Code and ANSI/NFPA 70-199. -
Page 4: Care And Maintenance
SAFETY INFORMATION CAUTION: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device (if applicable). CAN ICES-005 (B) / NMB-005 (B) This device complies with Part 15 of the FCC Rules. -
Page 5: Initial Installation
PREPARATION Before beginning the assembly of this product, ensure all parts are present. Compare all parts with the package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated assembly time: 2 hours Tools required (not included): Electrical tape, Phillips Screwdriver, Safety Glasses, Step Ladder, and Wire Strippers. - Page 6 STANDARD OR ANGLE MOUNT INSTRUCTIONS 1. Remove the downrod clip and downrod pin from the downrod. Then partially loosen the set screws in the yoke at the top of the motor assembly (Figure 3.1). 2. Feed the fan wires and braided cable through the yoke cover, canopy and downrod (Figure 3.2). 3.
-
Page 7: Final Installation
SECONDARY HANGING SYSTEM INSTRUCTIONS For installation in the United States: Building codes in the U.S.A. do not require installation of a Secondary Hanging System. If desired, the braided cable can be cut and removed using wire cutters (sold separately). Skip to FINAL INSTALLATION. For installation in Canada: In compliance with building codes in Canada, installation of the Secondary Hanging System is required. - Page 8 FINAL INSTALLATION 4. Insert each blade through a slot in the the side of the motor assembly. Align the holes of the blade with the holes in the blade arm. Secure each blade with the three blade screws and blade washers (Figure 5.4). 5.
-
Page 9: Troubleshooting
OPERATING INSTRUCTIONS 1. The fan pull chain has four positions to control fan speed. One pull is high, two is medium, three is low and four turns the fan off. The light pull chain has two positions to control the light, on and off (Figure 6.1). 2. -
Page 10: Limited Lifetime Warranty
4L166650001 HW Hardware Bag 4A000013340 4A000013320 4A000013330 4A000014220 The Honeywell Trademark is used under license from Honeywell International Inc ™. Honeywell International Inc. makes no representations or warranties with respect to this product. This product is manufactured for Hong Kong China Electric Appliance, LTD.