23. To install the fan with the LED light kit:
Remove the three fitter plate screws from fitter
plate. Then connect the 9-pin connector from the
motor assembly to the 9-pin connector from the
LED light kit. Ensure the plugs are connected
tightly (Fig. 23).
Fitter Plate Screw
24. Align holes in the switch housing with holes in the
fitter plate. Re-insert the previously removed fitter
plate screws. Use a Phillips screwdriver to secure
all screws (Fig. 24).
Fitter Plate Screw
25. Remove the preassembled rubber washer, hex nut,
finial cap, and finial from the LED light kit (Fig. 25).
LIGHT KIT INSTALLATION
14
Fig. 23
Fitter Plate
Fitter Plate Screw
LED Light Kit
Fig. 24
Fitter Plate
Screw
Fig. 25
Hex Nut
Finial Cap
9-pin
Connector
Switch
Housing
Rubber
Washer
Finial