Functional Description; Adjusting The Cutting Angle - Makita EN422MP Instruction Manual

14. Attach the felt pad (short) and felt pad (long).
Fig.19
► 1 . Felt pad (short) 2. Felt pad (long)
15. Attach the plate (large), cover, and under cover,
and then tighten 4 bolts.
1
Fig.20
► 1 . Bolt 2. Under cover 3. Cover 4. Plate (large)
1
2
The angle of the head can be adjusted in 13 steps. To
change the angle of the head, follow the steps below.
1.
the angle of the head while pulling the slide lever, and
then release the slide lever.
2
3
4
► 1 . Slide lever 2. Angle adjustment handle
2.
9 ENGLISH
NOTICE:
If the shear blades do not operate prop-
erly, the blades are not engaging the crank prop-
erly. Remove the blades and install them again.
NOTICE:
If the parts other than the shear blades
such as the crank are worn out, ask Makita
Authorized Service Centers for parts replacement
or repairs.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.

Adjusting the cutting angle

CAUTION:
Always be sure that the tool is
switched off before adjusting the cutting angle.
Hold the angle adjustment handle, and then adjust
2
Fig.21
Move the head slightly until it is locked with a click.
NOTE: Make sure that the head is securely locked
before operating the tool.
1