Table of Contents
Advertisement
Available languages
Available languages
2.
Remove the cap from the grease vessel. Align the
outlet of the grease vessel with the hole on the cover,
and then turn the grease vessel to attach the outlet of
the grease vessel into the hole.
1
Fig.34
► 1 . Grease vessel 2. Hole
3.
Apply the grease to the tool (Approximately 3 g
(0.1 oz) as a guide).
4.
Remove the grease vessel.
5.
Tighten the bolt.
Grinding the shear blades
NOTICE:
If the shear blades have considerably
deformed by grinding, replace the shear blades
with new ones.
1.
Install the battery cartridge to the tool.
2.
Turn on and start the tool so that the upper blade
and lower blade are positioned alternately.
Fig.35
3.
Turn off the tool and remove the battery cartridge
from the tool.
4.
Remove the screws and nut, and then remove the
tip guard from the shear blades.
2
3
Fig.36
► 1 . Screw 2. Nut 3. Tip guard
5.
Set the angle of a file to 45°, and grind the upper
blade from 3 directions with the file.
Fig.37
► ( 1) File (2) 45°
CAUTION:
make sure that the tool is switched off and the
battery cartridge is removed from the tool.
6.
Place the tool upside down, and then remove the
burrs from the shear blades with the dressing stone.
Fig.38
► 1 . Dressing stone
7.
Set the angle of the file to 45°, and grind the lower
blade from 3 directions with the file.
13 ENGLISH
1
1
Before grinding the shear blades,
1
2
1
2
Advertisement
Table of Contents
