Overload Protection - Makita XUC04 Instruction Manual

NOTICE:
Make sure that the cover of the battery
box is closed securely before use. Otherwise, mud,
dirt, or water may cause damage to the product or the
battery cartridge.
Installing the battery cartridge
1. Pull up the lock lever, and then open the cover of
the battery box.
Fig.28
► 1. Cover 2. Lock lever
2. Align the tongue on the battery cartridge with the
slot on the battery box, and then slide the cartridge until
it locks in place with a little click.
Fig.29
► 1. Battery cartridge
3. Insert the lock key in the place shown in the figure
as far as it will go, and turn it clockwise.
Fig.30
► 1. Lock key
NOTE: To turn the lock key, insert the lock key
completely.
1
2
1
4. Close the cover of the battery box.
Fig.31
► 1. Cover
Removing the battery cartridge
1.
Pull up the lock lever, and then open the cover of
the battery box.
2. Pull out the battery cartridge from the battery box
while sliding the button on the front of the cartridge.
1
Fig.32
► 1. Button
3. Turn the lock key counterclockwise, and pull it out.
4.
Close the cover of the battery box.
Machine / battery protection system
The machine is equipped with a machine/battery
protection system. This system automatically cuts off
power to the motor to extend machine and battery life.
The machine will automatically stop during operation
if the machine or battery cartridge is under one of the
following conditions.
A short beep sound or long beep sound is emitted
before the machine stops automatically. The battery
indicators and lamps on the control panel blink while the
beep sound is emitted.

Overload protection

When the machine/battery is operated in a manner
that causes it to draw an abnormally high current,
the machine automatically stops and the main power
lamp blinks in green. In this situation, turn the machine
off and stop the application that caused the machine
to become overloaded such as reducing the loaded
objects. Then turn the machine on to restart.
16 ENGLISH
1
1