Makita XUC04 Instruction Manual page 14

3. Place the carrier on the dump unit.
Insert the bolt from the top. Attach the flat washer and
spring washer in order to the bolt, and then tighten the
nut from the bottom. Tighten the rest of the bolts and
nuts in the same way.
Fig.21
► 1. Bolt 2. Flat washer 3. Spring washer 4. Nut
Removing the carrier
To remove the carrier, perform the installation proce-
dure in reverse.
Installing or removing the flat
bucket
Optional accessory
Installing the flat bucket
1.
Take out the flat bucket and holding frames from
the box.
Fig.22
► 1. Flat bucket 2. Holding frame
1
2
3
4
1
2
2. Assemble the holding frames by tightening 12
bolts.
Fig.23
► 1. Bolt
3. Remove the cord cover located in the lower right
corner on the rear of the machine.
Fig.24
► 1. Cord cover
14 ENGLISH
1
1