Installing The Carrier - Makita XUC04 Instruction Manual

3. Place the stay on the dump unit, and then tempo-
rarily tighten the bolts with the front pipe together. Install
the other stay to the dump unit in the same way.
1
2
Fig.17
► 1. Stay 2. Bolt
4. Place the bucket on the front pipe and left and
right stays.
Place the rubber washer on the hole of the bucket and
insert the bolt from the top. Attach the flat washer and
spring washer in order to the bolt, and then tighten the
nut from the bottom. Tighten the rest of the bolts and
nuts in the same way.
1
2
3
4
5
Fig.18
► 1. Bolt 2. Rubber washer 3. Flat washer 4. Spring
washer 5. Nut
5.
Securely tighten 4 bolts which were temporarily
tightened in step 3.
Removing the bucket
To remove the bucket, perform the installation proce-
dure in reverse.
Installing or removing the carrier
Optional accessory

Installing the carrier

1. Take out the carrier from the box, and attach the
side rails and front rail to the base frame.
Fig.19
2.
Tighten 6 thumb nuts together with springs and
washers to fix the rails.
Fig.20
► 1. Thumb nut 2. Spring 3. Washer
13 ENGLISH
1
2
3