Viewing The Client Adapter's Current Static Wep Key Settings; Entering A New Static Wep Key And Enabling Static Wep - Cisco Aironet 340 Series Installation And Configuration Manual

Chapter 4 Enabling Security Features

Viewing the Client Adapter's Current Static WEP Key Settings

Follow the steps below to view the client adapter's current static WEP key settings.
If you entered the password correctly in the Enter Password screen, the CEM screen appears (see
Step 1
Figure
Figure 4-3
A checkmark appears in the Already Set? box for all existing static WEP keys.
Note
Step 2 Perform one of the following:
•
•
•

Entering a New Static WEP Key and Enabling Static WEP

Follow the steps below to enter a new static WEP key for your client adapter.
If you entered the password correctly in the Enter Password screen, the CEM screen appears (see
Step 1
Figure
OL-1375-02
4-3).
CEM Screen
For security reasons, the codes for existing static WEP keys do not appear on the screen.
If no static WEP keys have been set, go to the
WEP" section on page 4-7
If you want to use an existing static WEP key, make sure the Transmit Key button to the left of the
key is selected and click OK. This is the key that will be used to transmit packets. Then open ACU
and make sure WEP is enabled.
If you want to overwrite an existing static WEP key, go to the
Key" section on page 4-9.
4-4).
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Windows CE
"Entering a New Static WEP Key and Enabling Static
to set up one or more static WEP keys.
Using Static WEP
"Overwriting an Existing Static WEP
4-7