Phone Setup; Connect To The Network - Cisco 8832 User Manual

Phone Setup

Table 4: Cisco IP Conference Phone 8832 User Guide Revisions for Firmware Release 12.1(1)
Revision
Updates to support for Cisco IP Conference
Phone 8832 PoE Injector
Support for Wireless Microphone
Support for Daisy Chain
Support for Cisco IP Conference Phone
8832 Non-PoE Ethernet Injector
Support for Wi-Fi
Support for Mobile and Remote Access
Through Expressway
Support for CMC and FAC

Phone Setup

Your administrator sets up your phone and connects it to the network. If your phone is not set up and connected,
contact your administrator for instructions.

Connect to the Network

You need to connect the phone to the network.
• Wired network connection—All wired network connections use one of the following:
Cisco IP Conference Phone 8832 User Guide
4
New or Updated Section
Connect to the Network, on page 4
• Your Cisco IP Conference Phone 8832 and 8832NR, on
page 1
• Wireless Expansion Microphone, on page 19
• Install the Wireless Expansion Microphones, on page 8
• Pair a Wireless Microphone, on page 9
• Unpair a Wireless Microphone, on page 9
• Install the Wireless Microphone Charging Cradle, on page
10
• Charge a Wireless Microphone, on page 11
• Your Cisco IP Conference Phone 8832 and 8832NR, on
page 1
• Daisy Chain Mode, on page 11
Connect to the Network, on page 4
• Connect to the Network, on page 4
• Set Up Wi-Fi Client, on page 6
• Connect to a Preconfigured Wi-Fi Network, on page 6
• Connect to the Network, on page 4
• Connect to Expressway, on page 7
Calls That Require a Billing Code or Authorization Code
Your Phone