14. Remove the canopy cover from the bottom of the
canopy (Fig. 14).
Helpful Hint: The downrod, yoke cover and
canopy cover are not used in this type of
installation.
15. Align the canopy with the holes in the top of motor
assembly. Then, secure the canopy to the top of
the motor assembly using the three closemount
screws from the hardware bag (Fig. 15).
Closemount Screw
16. Lift the fan and place the hole in the canopy on the
mounting bracket hook during the wiring process
(Fig. 16).
CLOSEMOUNT INSTRUCTIONS
10
Fig. 14
Canopy
Cover
Fig. 15
Closemount
Screws
Fig. 16
Hook
Canopy
Canopy