Blade Installation - Honeywell ELSTON Manual

20. Remove motor screws, motor blocks and washers
from underside of the motor assembly. Discard
the motor blocks and washers but keep the motor
screws for blade arm attachment. (Fig. 20).
Motor Screw
21. Partially insert the blade screws along with the
blade washers through the blade and into the
blade arm. Tighten each blade screw with a Phillips
screwdriver starting with the one in the middle.
Repeat this step for the remaining blades and
blade arms (Fig. 21).
Helpful Hint: A cutout in the fitter plate allows easy
access to the motor screw holes.
22. Insert two previously removed motor screws
through one blade arm and blade isolator and
into the motor assembly. Tighten motor screws
securely. Repeat for the remaining blade arms,
making sure to completely secure each blade arm
before proceeding to the next (Fig. 22).
Motor Screw

BLADE INSTALLATION

Motor Block Washer
Fig. 19
Fig. 20
Fig. 21
Blade Screw
Blade Washer
Fig. 22
13
Motor Block
Motor Screw
Washer
Blade Arm
Blade Isolator
Motor Screw
Blade
Cutout
Blade Arm