Honeywell ELSTON Manual page 15

26. Feed the fan pull chain from the switch housing
through chain guide and the grommet in the light
kit and then through the off-center hole in the glass
bowl. Then, feed the pull chain from the light kit
through the center hole in the glass bowl, rubber
washer and hex nut (Fig. 26).
27. Lift the glass bowl and rubber washer over the
threaded rod. Screw the hex nut onto the threaded
rod to secure the glass bowl. Feed the pull chains
through the appropriate holes in the finial cap. Lift
the finial cap up until it is flush with the glass bowl
and secure with the finial (Fig. 27).
Proceed to step 30.
LIGHT KIT INSTALLATION
15
Fig. 26
Chain
Guide
Switch Housing
Grommet
Rubber Washer
Hex Nut
Fig. 27
Rubber
Washer
Nut
Finial Cap
Finial