Honeywell ELSTON Manual page 16

28. (Optional) To install the fan without the light kit:
Unscrew the hex nut and washer from the threaded
rod in the switch housing to remove the LED light
kit and wiring (Fig. 28).
29. Remove the three fitter plate screws from the fitter
plate. Align holes in the switch housing with holes
in the fitter plate. Re-insert the previously removed
fitter plate screws. Use a Phillips screwdriver to
secure all screws. Plug the hole in the bottom of the
switch housing with the plug button (Fig. 29).
Plug Button Fitter Plate
Screw
30. Attach the pull chain extension(s) to the fan and
light pull chain (if applicable) (Fig. 30).
Fan Pull Chain
LIGHT KIT INSTALLATION
Light Pull Chain
Fig. 28
Switch
Housing
Fig. 29
Switch
Housing
Fig. 30
Light
Pull Chain
16 16
Hex Nut
Washer
LED Light Kit
Fitter Plate
Screw
Plug Button
Pull Chain
Fan