Configuration Using The Web Interface - Cisco Codec C Series Getting Started Manual

Cisco TelePresence Video Systems
Contents
Configuration using the web
interface
You have to use the touch controller or remote control for
the configurations until you know your system's iP address.
Finding the IP address
tap Settings > System Information on your touch controller;
or navigate to Home > Settings > System information
use the remote control and on-screen menu.
in both cases you can find the iPv4 Address and/or iPv6
Address of the system in the Network
Signing in to the web interface
1. open a web browser and enter the system's iP address
in the address bar.
2. enter your user name and password and click
the default user name is admin with no password set.
if you are not able to connect to the system:
• Make sure the system and computer are connected to
the same network.
• Make sure the system is switched on.
if the system has just been switched on, wait a few minutes
to allow the system to start up.
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
if you
section.
Sign In.
Confirguration Configuration
The web interface
23
Getting Started Guide
Appendices Contacts
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.