Cisco Codec C Series Getting Started Manual page 12

Cisco TelePresence Video Systems
Contents
Configuration using the Touch
controller
Waking up the system
if no menu is displayed on the touch controller, tap the display
to wake up the system.
if the system does not wake up:
• Make sure the touch controller is connected to the main unit.
• Make sure the main unit is connected to power and switched
on.
if the system has just been switched on, wait a few minutes
to allow the system to start up.
if in doubt, read the installation guide for your product.
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces Confirguration Configuration
Touch controller
12
Getting Started Guide
Appendices Contacts
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.