Cisco Codec C Series Getting Started Manual page 35

Cisco TelePresence Video Systems
Contents
Call key
Press the Call key to place a
call, and to accept an incom-
ing call.
use the Call button as a short-
cut to recent Calls when the
Call menu is not visible.
Clear
Press the Clear key to remove
characters in a text field.
Waking up the system
to wake up the system just
pick up the remote control or
press any key. You may have
to point the remote control
towards the system/camera
to make sure it discovers you.
Home key
Press the HoMe ( ) key
to open the Home menu
on screen.
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
end call / Standby
Press the end Call key to
reject an incoming call, to
end an ongoing call or—
when idle—to go into standby
mode. When navigating in
the menu the key is used to
exit the menu system.
Press and hold this key
to have the system enter
standby mode.
Rubber line sensors
When you pick up the
remote control and touch the
rubber line sensors along the
sides of the remote control,
the system wakes up.
Configuration
Alphanumeric keypad
the keypad behaves in a
similar way to the keypad on
a mobile phone.
0-9, a-z, period (.), @,
space, *
Press a key repeatedly to
toggle between the options
displayed on that key.
IR sensor range (DIP switch setting)
the ir sensor has a short and long range. When video conference systems are placed close to each
other, you may find it convenient to use the short range to avoid interfering with the other systems.
open the battery cover and remove the batteries to set the diP switch.
• Short range (1 m / 3 ft): Move the diP switch down.
• long range: Move the diP switch up.
The DIP switch
35
Getting Started Guide
Appendicies Appendices Contacts
Press and hold the #
key to toggle between
lower and upper case
characters and numbers
(depending on context).
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
abc/123 #