Cisco Codec C Series Getting Started Manual page 26

Cisco TelePresence Video Systems
Contents
Configuring H.323 and SIP
(when not set by a provisioning system)
to get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SiP protocol for video calls.
NoTe: Contact your system administrator, or service provider,
for information about the network settings.
for networks administered through Cisco tMS (Cisco
telePresence Management Suite) your Cisco tMS adminis-
trator will help you to get online.
You can find information about administering through Cisco
uCM in the Administering tC endpoints on CuCM
the diagnostics on your system will indicate if there is a problem
with the H.323 or SiP registering.
If you are changing a value setting,
you have to always click save to confirm the change.
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
H.323
if in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to the Configuration
2. open the
3. under Profile1
the E164 and the
4. Go to the
if you want the system to obtain the H.323 gatekeeper
address automatically, select
down list; if you want to enter the address manually, select
guide.
Manual.
if set to Manual
sponding input field.
5. if the H.323 gatekeeper requires authentication and you
want your system to authenticate itself to the gatekeeper,
go to the
the Mode
Password
otherwise, select
6. Click the
verify the H.323 settings.
if you successfully registered to a Gatekeeper the
is shown as
Please check the Administrator guide for your product if you
wish to change the other H.323 settings.
Confirguration Configuration
tab and select System Configuration.
H323 settings from the left column.
heading and the H323Alias subheading, enter
ID number in their respective input fields.
Gatekeeper subheading.
Auto in the Discovery
enter the gatekeeper Address in the corre-
Authentication subheading and select
drop down list. then enter the LoginName
in the corresponding input fields.
Off in the Mode drop down list.
Home tab to see the System Information
Registered in the H323 section.
26
Appendices
SIP
if in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to the Configuration
2. open the SIP page from the sidebar on the left.
3. under the Profle 1 heading, enter the SiP uri in the
input field, and optionally a display name in the
input field.
4. Select the preferred transpor t protocol from the
DefaultTransport drop down list. if you select Auto, the system
drop
first tries to connect using tls, then tCP, and finally udP.
5. Select a proxy type in the
type is Standard.
6. Go to the Proxy 1 subheading.
if you want the system to obtain the SiP proxy address
automatically, select Auto
if you want to enter the address manually, select Manual.
On in
if you select Manual enter the proxy
and
sponding input field.
7. if the SiP proxy requires authentication you must enter a
login name and password to authenticate your system. Go to
and
the Authentication 1 subheading and enter the
and Password in the corresponding input fields.
Status
8. Click the Home tab to see the
verify the SiP settings.
if you successfully registered to a SiP server the
shown as Registered
Please check the Administrator guide for your product if you
wish to change the other SiP settings.
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts
tab and select System Configuration.
URI 1
DisplayName
Type drop down list. the default
in the Discovery drop down list;
Address in the corre-
LoginName
System Information and
Status is
in the SiP section.