Cisco Codec C Series Getting Started Manual page 17

Cisco TelePresence Video Systems
Contents
Configuration using the remote
control and on-screen menu*
Waking up the system
if there is no menu on screen, press
control to show the menu.
if the system does not show a menu on screen:
• Make sure the monitor is connected and has been switched
on.
• Make sure the remote control has batteries installed.
• Make sure the system is switched on.
if the system has just been switched on, wait a few minutes
to allow the system to start up.
if there is still no menu on screen, make sure the
m o n i to r c a b l e i s c o n n e c te d to t h e b a s i c v i d e o
output. connector. if in doubt, see the installation guide for
your product.
* this section does not apply for eX and MX series.
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
Home ( ) on the remote
Confirguration Configuration
Remote control and
on-screen menu
17
Getting Started Guide
Appendices Contacts
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.