Cisco Codec C Series Getting Started Manual page 20

Cisco TelePresence Video Systems
Contents
Configuring H.323 and SIP
(when not set by a provisioning system)
to get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SiP protocol for video calls.
NoTe: Contact your system administrator, or service provider,
for information about the network settings.
for networks administered through Cisco tMS (Cisco
telePresence Management Suite) your Cisco tMS adminis-
trator will help you to get online.
You can find information about admininistering through Cisco
uCM in the Administering tC endpoints on CuCM
Always save the new value when you change a setting
• drop down list selection: Navigate to the correct value
and press the OK ( ) key to save, or press the left arrow
key to leave without saving.
• text entry in an input field: enter the text, navigate to
Ok/Save to save the change, or navigate to
leave without saving; then press theOK
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
H.323
if in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to Home > Settings > Administrator settings > Advanced
configuration > H323 > Profile
2. Go to H323Alias
corresponding input fields.
3. if you want the system to obtain the H.323 gatekeeper
address automatically, go to
in the Discovery
address manually, select
if set to
guide.
Address
4. if the H.323 gatekeeper requires authentication and you
want your system to authenticate itself to the gatekeeper,
go to Authentication
list; otherwise select
if set to On
corresponding input fields.
5. Go to Home > Settings > System information
the H323 settings.
if you successfully registered to the Gatekeeper the
is shown as
6. Press Home
Please check the administrator guide for your product if you
want to change the other H.323 settings.
Cancel to
( ) key to confirm.
Confirguration Configuration
1.
and enter the E164 number and ID
Gatekeeper and select
drop down list; if you want to enter the
Manual.
Manual enter the gatekeeper address in the
input field.
and select On in the Mode drop down
Off.
enter the LoginName and Password
and verify
Registered in the H323 section.
( ) to exit.
20
Appendices
SIP
if in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to Home > Settings > Administrator settings > Advanced
configuration > SIP > Profile
in the 2. Go to URI and enter the SiP uri in the corresponding
input field.
3. Select your preferred
Auto drop down list. if you select
connect using tls, then tCP, and finally udP.
4. Select your preferred proxy
default type is Standard.
5. Go to Proxy 1. if you want the system to obtain the SiP
proxy address automatically, select
drop down list; if you want to enter the address manually,
select Manual.
if set to Manual enter the proxy address in the
input field.
in the
6. if the SiP proxy requires authentication you must enter a
login name and password to authenticate your system. Go
to Authentication 1 and enter the
in the corresponding input fields.
Status
7. Go to Home > Settings > System information
the SiP settings.
if you successfully registered to a SiP server the
shown as Registered
8. Press Home ( ) to exit.
Please check the administrator guide for your product if you
want to change the other SiP settings.
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts
1.
DefaultTransport protocol in the
Auto the system first tries to
Type in the drop down list. the
Auto in the Discovery
Address
LoginName and Password
and verify
Status is
in the SiP section.