Cisco Codec C Series Getting Started Manual page 21

Cisco TelePresence Video Systems
Contents
Setting date, time and location
(when not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among other
things this information is used to time stamp messages trans-
mitted to gatekeepers and other network elements.
the time and date is shown in the top right corner of the main
display. it takes a few moments before the time on the screen
changes after changing the setup.
Always save the new value when you change a setting
• drop down list selection: Navigate to the correct value
and press the OK ( ) key to save, or press the left arrow
key to leave without saving.
• text entry in an input field: enter the text, navigate to
Save to save the change, or navigate to
without saving; then press the OK
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
1. Go to Home > Settings > Date and
2. Select 24 hours
drop down list as you prefer.
3. Select Day.Month.Year,
in the Date format
4. Select your time zone in the
5. Select Auto,
list as you prefer.
if you select Manual, also enter the
in the corresponding input field.
if you select
Month,
6. Press Home
NtP mode:
1
Auto: the time is regularly updated using an NtP server. the
NtP server address is automatically obtained from the
network (dHCP).
Manual: the time is regularly updated using an NtP server. You
must manually enter the NtP server address.
Off: You must set the time manually. the time is not
Ok/
updated automatically.
Cancel to leave
( ) key to confirm.
Confirguration Configuration
time.
or 12 hours (am/pm) in the Time format
Month.Day.Year or Year.Month.Day
drop down list as you prefer.
Time zone drop down list.
Manual or Off in the NTP mode drop down
1
NTP server
Off, also select the correct value for Day,
Year and Time in the corresponding drop down lists.
( ) to exit.
21
Appendices
address
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts