Cisco Codec C Series Getting Started Manual page 14

Cisco TelePresence Video Systems
Contents
Configuring IP
(when not set by a provisioning system)
Your video conference system supports both iP version 4
(iPv4) and iP version 6 (iPv6). in both cases, the iP param-
eters can be assigned automatically by the network, or you
can set everything manually.
if you want to set the parameters manually, please contact
your network administrator to obtain the required parameters.
if your system is provisioned automatically, these iP settings
may be overridden by the provisioning system.
if an iPv4 or iPv6 address is already assigned to the system, you
will find it in the NetWork section on the System information
page:
tap Settings (  ) > System Information.
NoTe: You must restart the system after changing the iP
settings for the changes to take effect
* iP Assignment:
dHCPv6: All iPv6 addresses, including options, are obtained
automatically from a dHCPv6 server.
Autoconf: the system and gateway iP addresses will be assigned
automatically. the options, e.g. NtP and dNS server addresses, must
be set/assigned according to the dHCP options setting. **
Static: the system and gateway iP addresses must be configured
manually. the options, e.g. NtP and dNS server addresses, must be
set/assigned according to the dHCP options setting. **
* dHCP options:
on: the iP parameters, like the dNS and NtP server addresses, will be
obtained automatically from a dHCPv6 server.
off: the iP parameters, like the dNS and NtP server addresses, must
be set manually.
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
To set or change the IPv4 settings
1. Choose IP version
tap Settings (  ) > Administrator > IP &
IPv4 in the
2. Choose automatic or manual IP assignment
tap DHCP in the
iP assignment; or Static if you want to set the iP addresses
manually.
3. If IP Assignment is Static: Set the IP addresses
enter the
Server address. A soft keyboard appears when you tap
an input field.
4. Save the settings
tap Save
saving.
5. Return to the main menu
tap Exit to return to the home menu.
Confirguration Configuration
VLAN. then tap
IP Version section.
IP Assignment section if you want automatic
IP Address, Subnet Mask, Gateway, and
to save the changes, or Undo to leave without
14
Appendices
To set or change the IPv6 settings
1. Choose IP version
tap Settings (  ) > Administrator > IP &
IPv6 in the IP Version
2. Choose automatic or manual IP assignment
Choose DHCPv6, Autoconf or Static in the
section according to your network requirements.*
3. If IP Assignment is Static: Set the IP addresses
enter the IP Address and Gateway. A soft keyboard appears
DNS when you tap an input field.
4. If IP Assignment is Static or Autoconf:
DHCPoptions
tap on or off in the DHCP Options
your network requirements.**
if dHCP options are switched off, you must set the dNS
and NtP server addresses on the web interface.
5. Save the settings
tap Save to save the changes, or
saving.
6. Return to the main menu
tap Exit to return to the home menu.
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts
VLAN. then tap
section.
IP Assignment
section according to
Undo to leave without