Brother ADS-4300N Online User's Manual page 238

Difficulties
Cannot save the settings
in Remote Setup or Web
Based Management.
Cannot start Remote
Setup.
Cannot enter the IP
address and Subnet
Mask.
(ADS-4700W/
ADS-4900W)
The computer has
detected a USB flash
drive.
Other Difficulties
Difficulties
The machine is in Sleep
Mode (power save
mode).
The machine is not
turned on.
Your computer cannot
find the machine via
USB interface.
The Dust Detected
message does not
disappear.
(ADS-4700W/
ADS-4900W)
Related Information
• If You Are Having Difficulty with Your Machine
Cause
The machine is processing.
The machine is turned off.
The machine is not connected to your
computer.
An error is occurring.
The machine is scanning.
The machine is being configured from
the machine's Control Panel.
(ADS-4700W/ADS-4900W)
A USB flash drive is inserted into the
machine.
"000.000.000.000." has already been
entered.
A USB flash drive is inserted into the
machine and the computer is
connected to the machine using a
USB cable.
Cause
The machine is idle and the amount
of time specified by the Sleep Mode
setting has elapsed.
The machine was plugged in within
60 seconds after pulling out the plug.
A USB flash drive is inserted.
The scanner driver is not installed.
There may be dirt remaining on one
of the glass strips inside the machine.
Suggestions
Wait until the machine finishes processing, and
then try again.
Turn the machine on, and then try again.
Connect the machine to your computer, and then
try again.
Clear all errors, check the status is Ready on
Remote Setup and then try again.
Wait until scanning has finished and try again.
Stop configuring the machine from the Control
Panel.
Remove the USB flash drive.
Press to delete the entered information, and
then enter the correct information.
The computer detects the USB flash drive that is
inserted into the machine. Remove the USB flash
drive so that the computer does not detect it.
Suggestions
Do one of the following:
• Press .
• Press . (ADS-4700W/ADS-4900W)
• Scan using your computer.
• Open the Front Cover.
• Load your document.
• Touch the screen. (ADS-4700W/ADS-4900W)
• Insert/disconnect the USB flash drive.
• Insert/disconnect the USB cable from the
machine or PC.
Wait 60 seconds, and then turn the machine on.
Remove the USB flash drive.
Install the scanner driver.
Clean both glass strips correctly.
See Related Information: Clean the Scanner and
Rollers.
233