Advertisement
Install Cisco ISE Software on Cisco SNS Appliances
Front Panel LEDs
Temperature status
Power supply status
Network link activity
Cisco SNS 3515 or SNS 3595 Appliance Back Panel View
The following figure shows the components of the Cisco SNS-3515 and Cisco 3595 appliance back panel
view.
Figure 2: Back Panel LEDs
1
Grounding-lug hole (for DC power
supplies)
2
PCIe riser 1/slot 1
3
PCIe riser 2/slot 2
4
1-GbE Ethernet port (Eth 2)
5
1-GbE Ethernet port (Eth 3)
6
1-GbE Ethernet port (Eth 4)
7
1-GbE Ethernet port (Eth 5)
Cisco SNS 3515 or SNS 3595 Appliance Back Panel View
• Green—The server is operating at normal
temperature.
• Amber, steady—One or more temperature
sensors breached the critical threshold.
• Amber, blinking—One or more temperature
sensors breached the non-recoverable threshold.
• Green—All power supplies are operating
normally.
• Amber, steady—One or more power supplies are
in a degraded operational state.
• Amber, blinking—One or more power supplies
are in a critical fault state.
• Off—The Ethernet link is idle.
• Green—One or more Ethernet LOM ports are
link-active, but there is no activity.
• Green, blinking—One or more Ethernet LOM
ports are link-active, with activity.
9
1-GbE Ethernet dedicated management port;
used to access CIMC
10
Serial port (RJ-45 connector)
11
1-GbE Ethernet port (Eth 0)
12
1-GbE Ethernet port (Eth 1)
13
VGA video port (DB-15)
14
Rear unit identification button/LED
15
Power supplies (up to two, redundant as
Install Cisco ISE Software on Cisco SNS Appliances
1+1)
5
Advertisement
