Advertisement
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
Note
Do not mix power supply types in the server. Both power supplies must be identical.
770-WAC Power Supply
Description
AC input voltage range
AC input frequency
AC line input current (steady state)
Maximum output power for each power supply
Power supply output voltage
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware
Appliances
This section describes how to install your Cisco SNS 3515 or 3595 appliance and connect it to the network.
It contains:
•
•
•
•
Before you begin the installation, read the
3515 or Cisco SNS 3595 Hardware
Warning
Warning: Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Warning: This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Install Cisco ISE Software on Cisco SNS Appliances
14
Install the Cisco SNS 3515 or 3595 Appliance in a Rack, on page 15
Cisco Integrated Management Controller, on page 24
Connect Cables, on page 19
Connect and Power On the Cisco SNS 3515 or 3595 Appliance, on page 22
Install Cisco ISE Software on Cisco SNS Appliances
Specification
90 to 264 VAC (self-ranging, 100 to 264 VAC
nominal)
Range: 47 to 63 Hz (single phase, 50 to 60 Hz
nominal)
9.5 A peak at 100 VAC
4.5 A peak at 208 VAC
770 W
Main power: 12 VDC
Standby power: 12 VDC
Regulatory Compliance and Safety Information for the Cisco SNS
Appliance.
Advertisement
