Advertisement
Install Cisco ISE Software on Cisco SNS Appliances
Figure 9: Reverse the CMA
1
CMA tab on end of width-adjustment slider
Connect Cables
This section describes how to connect your Cisco SNS-3515 or Cisco SNS-3595 appliance to the network
and the appliance console.
•
•
•
•
Attach cables (such as keyboard, monitor cables, if required) to the rear of the server. Route the cables properly
and use the cable straps to secure the cables to the slide rails. See the
Back Panel View, on page 5
Connect the Network Interface
Warning
Warning: Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
This section describes how to connect the Cisco SNS-3515 or Cisco SNS-3595 appliance Ethernet port.
The Ethernet connector supports Serial over LAN (SOL) cables. The RJ-45 port supports standard
straight-through and crossover Category 5 unshielded twisted-pair (UTP) cables. Cisco does not supply
Category 5 UTP cables; these cables are available commercially.
To connect the cable to the appliance Ethernet port:
Step 1
Verify that the appliance is turned off.
Connect the Network Interface, on page 19
Connect the Console, on page 21
Connect the Keyboard and Video Monitor, on page 21
Cable Management, on page 22
for reference on the rear view of the appliance.
2
Metal button for rotating
Cisco SNS 3515 or SNS 3595 Appliance
Install Cisco ISE Software on Cisco SNS Appliances
Connect Cables
19
Advertisement
