GE Vivid S5 N Service Manual page 153

P R E L I M I N A R Y
GE
P N FN091065, R
ART UMBER
.
6.) Proceed as follows:
a.) Loosen the screw to open the plastic cable clamp (see
b.) Route the AC power cable upwards and through the clamp.
c.) Screw the plastic cable clamp into position on the support column (see
.
Figure 3-89 Mains Power Cable Secured with Plastic Cable Clamp
7.) Connect the other end (male plug) of the AC Power Cable to a hospital-grade mains power outlet
with the proper rated voltage.
8.) Turn ON the circuit breaker at the rear of the system.
The unit is now ready for Power ON/Boot Up. Refer to the instructions for
on page
2
EVISION
Figure 3-88 Plastic Cable Clamp and Securing Screw
tightening the screw sufficiently to secure the cable firmly in the clamp.
Take care not to overtighten the screw, or damage the cable!
4-5.
Chapter 3 - System Setup
VS5 N VS6 N
S
AND ERVICE
Screw hole for Securing
Plastic Cable Clamp
Plastic Cable Clamp
and Screw
Figure 3-88).
Figure 3-89), carefully
Plastic Cable Clamp
Screw
AC Power Cable
'Turning the System ON"
M
ANUAL
3-77