Getting Started With The Handset; Figure 3-1: Handset's Batteries; Figure 3-2: Handset On Charger - Linksys CIT300 User Manual

Dual-Mode Internet Telephony Kit

Getting Started with the Handset

To insert the batteries and charge them, follow these instructions:
1. Remove the cover of the battery compartment.
2. Insert the two NiMH rechargeable, AAA batteries (included). Make sure the polarities are
correct. (The + and - ends of the batteries should be in the + and - slots of the compartment.)
3. Slide the cover upward until it snaps into place.
4. Plug the charger's power adapter into an electrical outlet.
5. Place the handset on the charger. For the initial charge, let the batteries charge for 14 hours
before using the handset. This maximizes battery performance and life.
NOTE: The handset may become warm during the initial charge.
NOTE: If the batteries are low, the handset may not power on for up to 15 minutes
and will emit a warning tone. Place the handset on the charger to recharge.
Proceed to the next section, "Getting Started with the USB Base Station."
14
Figure 3-1: Handset's
Figure 3-2: Handset on
Batteries
Getting Started with the Handset
Charger
Chapter 3: Getting Started