Managing The Handsets - Linksys CIT300 User Manual

Managing the Handsets

This section describes a variety of system features. A handset must be linked to the USB base station in order to
use any of the system features mentioned in this section, except for the registration feature.
Registering a Handset
By default, the handset is registered to its USB base station and ready for use. You only have to register the
handset if it indicates that it is not registered. You can register the handset with up to four USB base stations,
and each USB base station can register up to four handsets.
1. When the handset says, "UNREGISTERED", select REG.
2. Select OK.
3. Press and hold down the page button on the USB base station until the LEDs of the USB base station flash.
4. On the handset, enter the Personal Identification Number (PIN) code. The default is 0000.
5. Select OK.
After the handset has been registered, you will see a confirmation screen. The handset will be in standby mode
and display its name, its number, and the Base/Handset Link icon.
If the registration fails, then you will see a warning screen. The Base/Handset Link icon will flash, and the
handset will not display its number. Repeat the registration procedure.
Chapter 4: Using the Dual-Mode Internet Telephony Kit
Managing the Handsets
Dual-Mode Internet Telephony Kit
67