First Use; Using Your Toothbrush - Oral-B iO6 Manual

maker while turned on. Anytime you suspect inter ference is
taking place disable Bluetooth.
Specifications
For voltage specifications refer to the bottom of the charging
unit.
Noise level: 64 dB (A)

First use

Please wake up your toothbrush by pressing the on/off button
(7) and follow the instructions on the interactive display (4) to
get started for first time setup.
If not further instructed on the display, you may toggle with the
mode button (8) and select with the on/off button (7).
You may change the settings via the «Settings» menu (17) at any
time.
Charging and Operating
• To charge the battery place the toothbrush on the
plugged-in charger (6).
• The charge level is indicated on the inter active display (4).
Once it is fully charged the display turns off. A full charge
typically takes 12 hours.
• If the battery is running low the motor reduces its speed and
the Smart Pressure Sensor (3) shortly blinks in red. Once
the battery is empty, the motor stops; it will need at least a
30-minutes charge for one usage.
Note: In case the battery is empty (display off), charge for at
least 30 minutes.
• You can always store the handle on the plugged-in charger
to maintain it at full charge; a battery overcharge is pre-
vented by the device.
Note: Store handle at room temperature for optimal battery
maintenance.
Caution: Do not expose handle to temperatures higher than
50°C / 122°F.

Using your toothbrush

Start Brushing
Place the brush head on the handle. A small gap should remain
between handle and brush head.
Lift the handle off the plugged-in charger or simply pick it up to
wake up the handle (display turns on). Wet brush head and
apply toothpaste. To avoid splashing, guide the brush head to
your teeth before switching the handle on by pressing the on/
off button.
8
91451398 _iO6_EE_75x155.indd 8 91451398 _iO6_EE_75x155.indd 8 23.11.20 10:09 23.11.20 10:09