9: Ann-Bus - Honeywell Fire-Lite Alarms MS-5UD Series Manual

Read Status
4.19.9 ANN-BUS
READ STATUS
1=HISTORY
2=PRINTER
3=ANN-BUS
Read Status Screen #3
MS-5UD & MS-10UD Series Manual — P/N 52626:C2 1/24/2012
Pressing 1 while viewing the Print Screen allows the user to print the History file which will detail
all of the system activities since the file was last cleared from memory.
Pressing 2 while viewing the Print Screen allows the user to print the Walktest log which will detail
all of the system activations during walktest since the log was last cleared. Refer to "Walktest" on
page 103 for additional information on the display.
Pressing 3 while viewing the Print Screen will exit the Print operation.
Pressing 3 while viewing Read Status Screen #3 will display the settings for the ANN-BUS options
as shown in the following screens:
BUS ENABLED
1=BUS MODULES
2=ANN-S/PG OPTIONS
1=ANN-80 OPTIONS
2=ANN-RLY OPTION
3=ANN-AUDIO OPTIONS
ANN-BUS Screen #1 indicates whether the ANN-BUS is enabled (Yes/No).
Pressing 1 while viewing ANN-BUS Screen #1 will display BUS Module addresses 1-8 and the
devices, if any, located at those addresses.
Pressing 2 while viewing ANN-BUS Screen #1 will display the printer settings for the printer con-
nected to the FACP. This information includes:
• Serial or Parallel printer
• Printer Supervision (Yes or No)
• Off-line Timer setting
• Baud Rate
• Data Bits
• Parity
• Stop Bits
Pressing 1 while viewing ANN-BUS Screen #2 will display the programmed options for the ANN-
80 devices connected to the ANN-BUS. These include Piezo enable/disable, Lock enable/disable
and which buttons/keys on the annunciator are enabled/disabled.
Pressing 2 while viewing ANN-BUS Screen #2 will display the zone programming for each ANN-
RLY relay.
Pressing 3 while viewing ANN-BUS Screen #2 will display the zone, if any, that has been assigned
as the All-Call Zone.
ANN-BUS
ANN-BUS Screen #1
ANN-BUS
ANN-BUS Screen #2
Operating Instructions
NO
125