Table of Contents
Advertisement
Assembly
The Model G0792 comes with the headstock in
the horizontal position. To safely lift the machine,
you must first adjust the headstock to the vertical
position and install the upper roller crank handle.
To assemble machine:
1.
Use an 8mm hex wrench to remove two cap
screws that secure headstock in horizontal
position (see Figure 7).
Cap Screws
(1 of 2)
Figure 7. Location of cap screws that secure
headstock in horizontal position.
2.
With help from an assistant, gently tilt head-
stock up until it rests on base (see Figure 8).
3.
Use cap screws removed in Step 1 to secure
headstock to base (see Figure 8).
4.
Install upper roller crank handle and ball
knob, as shown in Figure 8.
Crank
Handle
Cap
Screws
Figure 8. Machine assembled for lifting.
-14-
Lifting & Placing
To lift and place the machine, wrap a lifting
strap rated for at least 750 lbs. around the crank
handle, as shown in Figure 9, then use a forklift
to lift the machine off of the pallet and onto a suit-
able location.
Ball
Knob
HEAVY LIFT!
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
Figure 9. Lifting Model G0792.
Model G0792 (Mfd. Since 12/15)
Lifting
Strap
Advertisement
Table of Contents
