Follow the instructions below to install a hard drive, connect to the network, and power on the DNS-313. Open the shipping carton for the DNS-313
and carefully remove and unwrap its contents. Follow the instructions below to setup the DNS-313. If this is the first time you are using the DNS-313
or if a new hard disk is installed, use the Click n' Connect configuration utility located on the Installation CD and follow the instructions for setting up,
configuring, and formatting the new drive.
1. Access the drive bay by sliding the faceplate up until it unlatches from the device.
2. Once the faceplate is unlatched, pull it off the device, exposing the drive bay.