Setup Utilities - D-Link STORAGE DNS-313 User Manual

Setup Utility

Setup Utilities

The Setup Utility on the Installation CD is used when setting up the DNS-313 for the first time or, after the hard disk has been formatted, to establish
and configure IP settings and map the drive to your Windows computer.
To use the Click n' Connect utility for initial setup, insert the Installation CD into your computer's CD-ROM drive and follow the instructions in the
next section. After inserting the CD, the menu below should appear on the desktop after a few seconds. In addition to Click n' Connect Quick
Installation, use this menu to launch the Easy Search Utility or any of the options listed in the bullet list in the right side panel.
The Click n' Connect utility will walk you through the complete installation process including inserting a SATA hard drive, formatting the disk, and
mapping the drive to your computer. The Easy Search Utility can be used to establish IP settings, and later to map the network drive to your computer.
The Easy Search Utility cannot be used with an unformatted hard drive, so use Click n' Connect for initial setup, then use Easy Search on any
computer that will be using the network storage drive.
Both the Click n' Connect and Easy Search utilities are described in separate sections
below.
D-Link DNS-313 User Manual
9