Adjusting The Handle Height - Makita DCU180 Instruction Manual

Lighting up the front lamps
Press the lamp button on the battery box to light up
the lamps. To turn off the lamps, press the lamp button
again.
1
2
► 1 . Lamp button 2. Lamp
NOTE: The lamps go off if the machine is left unat-
tended for approximately 10 minutes.
NOTE: The lamps go off when the power is turned off.
NOTE: You can light up the lamps even if the lock key
is not inserted.

Adjusting the handle height

Remove the short hexagonal bolts and shoulder bolts
using the wrench included in the package, and then
adjust the handle height. The height can be adjusted to
three levels. Tighten the shoulder bolts and short hex-
agonal bolts to fix the handle.
► 1 . Short hexagonal bolt 2. Shoulder bolt
2
NOTICE:
same height.
NOTICE:
bolts with excessive force. Tighten them with
proper force so that the handles are stably fixed.
NOTICE:
Adjusting the width of the carrier
Loosen the 4 thumb nuts, and then slide the side rails.
Tighten the thumb nuts to fix the side rails.
2
1
► 1 . Thumb nut 2. Rail
17 ENGLISH
2
Fix the left and right handles at the
Do not tighten the short hexagonal
Do not pinch the cords with the bolts.
1
1
1
1