Control Panel; Rear Wheel Brake - Makita DCU180 Instruction Manual

Control panel

► 1 . Power button 2. Forward/reverse button 3. Speed
button
To turn the power on, press the power button for a few
seconds. Press the forward/reverse button to switch
between the forward mode and reverse mode. Press
the speed button to switch between low speed and high
speed. When the power is turned on, the forward mode
and low speed are set. To turn the power off, press the
power button for a few seconds.
NOTE: The forward/reverse button is not available
while pulling the switch trigger.
NOTE: A short beep sound comes out when operat-
ing the machine in reverse.
NOTE: The speed button is not available when oper-
ating the machine in reverse.
Switch and brake action
WARNING:
Before installing the battery car-
tridge into the machine, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the machine, pull the switch trigger. To stop the
machine, release the switch trigger and pull the brake
lever. To lock the brake lever, press the lock button
while pulling the brake lever. To release the lock, pull
the brake lever.
1
► 1 . Switch trigger
1
2 3
16 ENGLISH
► 1 . Lock button 2. Brake lever

Rear wheel brake

The rear wheels are equipped with the brakes. Press
the brake pedals toward the front to lock the brakes. To
release the brakes, press the brake pedals toward the
rear.
► 1 . Pedal
1
2
1