Scanning An Image From An Application - Canon imageCLASS MF5730 Software Manual

Scanning an Image from an Application

You can scan an image from a TWAIN- or WIA- (Windows XP only) compliant
application and use the image in that application.
This procedure varies depending on the application. The following is only one
example. For the correct procedure, refer to the documentation of the application
you are using.
1
Place the document face-down on the platen glass or load it
face-up in the ADF.
2
Open the application from which you will scan the document.
3
Select the command to scan.
In most cases, select [Import] or [Acquire image] etc. from the [File] menu.
4
Select the scanner driver to be used.
With Windows XP, you can use the ScanGear MF or the WIA driver as the scanner
driver.
To use ScanGear MF, select [Canon MF5730], [Canon MF5750] or [Canon MF5770].
To use the WIA driver, select [WIA Canon MF5730], [WIA Canon MF5750] or [WIA
Canon MF5770].
5
Specify the scanner settings ➞ click [Scan].
For details, see "Setting Preferences and Scanning with ScanGear MF," on p. 3-19, or
"Scanning with the WIA Driver (Windows XP Only)," on p. 3-46.
When scanning is completed, the scanned image will appear in the application's
display area.
NOTE
If white lines appear on one edge of the scanned image, check that the document is
correctly placed on the platen glass. A document should be placed approximately
mm) from the front edge (i.e., the edge closest to the operation panel) of the platen glass.
Scanning an Image from an Application
3
1
/ " (3
8
3-15