Table of Contents
Advertisement
Yearly Service -
usage.
Failure to inspect and maintain the fireplace may lead to improper combustion and a potentially dangerous situation.
We recommend the following procedures be done by a qualified technician.
Glass Maintenance
•
Always use suction cups to remove the fireplace glass. Use the manual procedure for instruction on how to
remove the fireplace glass. Always use gloves when removing the glass to protect your hand and prevent
fingerprints on the glass.
•
DO NOT USE abrasive cleaners on the glass panels. DO NOT ATTEMPT to clean the glass panels when they are
hot.
•
Do not use normal household (usually ammonia-based) glass cleaners to clean the glass as these cleaners can
leave a permanent stain. Only a gas fireplace glass cleaner should be used.
•
Verify no cracks or breakage in the glass.
•
Place glass in a safe location to prevent breakage.
•
Never attempt to operate the fireplace without the fireplace glass.
Pilot Maintenance
• Visually inspect the pilot flame. The pilot flame should be always present when the fireplace is in operation.
• Make sure the pilot flame has two flame tips pointing to the flame sensor (thermocouple) and to the center of the burner.
• Make sure the pilot area is clean from any dust, media or any other debris that may disrupt the operation of the ignition
system. Lint or foreign material must be removed with a brush or vacuum.
• Verify fireplace ignition using the remote or wall switch. Verify electronic ignition, sparking sequence, pilot operation and
burner ignition.
Burner Maintenance
• The flames from the burner should be visually checked. The flame should have a blue base and yellow tops and be candle-
like in appearance.
• If excessive soot is found inside the firebox area, the fireplace will require adjustment. Verify the air shutter and vent
restrictor setting and document any changes.
• If the flame becomes sooty, dark orange in color, or extremely tall, do not operate the heater.
• Measure gas pressure. Inlet _______ W.C., Outlet _______ W.C.
Vent Maintenance
The following venting system inspection by a qualified service technician is recommended every six months:
• Inspect for excessive condensation, e.g. water droplets forming in the inner lining and subsequently dripping out of the
joints. This can cause corrosion in the system.
• Check for corrosion in areas exposed to the elements. Where rust spots or holes have appeared, these must be immediately
replaced.
• Ensure that there is no foreign material in the vents. Survey by removing the cap and shining a light down the vent.
• Check all joints and pipes to make sure that nothing has been disturbed or loosened.
Double Glass Fans
• Disconnect power to the Flare control system.
• Remove the external glass and the covering trim.
• Inspect the fans around the Flare firebox and make sure they are all turning.
• Clean all fans with a brush and vacuum to remove any dust or debris.
• Inspect the lower fireplace intake. Clean the lower vent intake with a brush and vacuum any dust or debris.
• Connect back the Flare control power and press the Flare remote arrow down. Make sure all fans are working properly.
• Turn off the fans and install back the trim and glass.
91 |
P a g e
Commercial fireplaces may need to be serviced more frequently depending on
Advertisement
Table of Contents
