Leg Setup For Corner Units - Honeywell Flare Front Series Installation Manual

LEG SETUP FOR CORNER UNITS

Included are 4 screws, 2 adjustable legs, 1 foot for fine tuning, and 1 special wrench for adjusting the feet while the
fireplace is standing.
•
First, identify the correct order to connect the legs. The first adjustable leg that attaches to the fireplace has
Rivnuts as seen in the image below. The second adjustable leg has a place for the foot to be screwed in on
the bottom as seen in the images below.
•
Next, determine which holes to insert the 4 screws so that the fireplace will stand at the desired height after
the foot for fine tuning is also screwed in.
•
Insert the 4 screws into the holes and Rivnuts beneath and tighten. Screw in the foot so that it can later be
adjusted to slightly raise or lower the fireplace.
•
Configure remaining legs to the same height.
•
Stand the fireplace up and fine tune the feet with the wrench provided so the fireplace is level. Open the
screws to raise the fireplace. Close the screws to lower the fireplace.
24 | P a g e
The levelers are used for
fine tuning & should only be
adjusted once the fireplace is
standing.
Opening or extending the
legs too much will cause the
fireplace to become unstable