Table of Contents
Advertisement
FIREPLACE OPERATION
ELECTRICAL AND POWER REQUIREMENTS
Screen Unit: 110V, 15A Outlet (Dedicated circuit is optional but recommended) or Directly wired. When using an outlet, make sure
the outlet is accessible in the event of servicing.
**110V, 15A additional power source needed if Optional RGB-LEDs are included in unit.
Double Glass: 110V, 15A Outlet (Dedicated circuit is optional but recommended) or Directly wired. When using an outlet, make
sure the outlet is accessible in the event of servicing.
**No additional power source needed for optional RGB-LEDs.
ON/OFF OPERATION
of the fireplace. Plug can also be removed to connect directly for hardwire operation.
The ON Off operation on the Flare Fireplaces with a Honeywell valve is controlled by switching ON or Off power supply to the
fireplace plug or hotwire.
The Fireplace will attempt to start whenever electric power is supplied to it. The Fireplace power supply needs to be wired by
QUALIFIED ELECTRICIAN.
The electrician can provide the operator a switch to control the outlet the fireplace is connected to.
The use of the plug should only be done when access to the outlet is available even after installation is completed.
This appliance must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is professionally installed and
grounded in accordance with all local codes and ordinances.
9 |
P a g e
Advertisement
Table of Contents
