Install Workstation In Classic Console Using Slide Mount Option - Honeywell T5810XL Planning, Installation And Service Manual

14. Go to section,
3.7.3

Install workstation in Classic console using slide mount option

1. Remove both the front and rear console doors to access the workstation mounting location.
2. If the retaining brackets are attached, loosen the two captivated fasteners on each retaining bracket
and remove them.
3. Verify that the slide mount bottom and sides are clear of any installed cables.
4. Using the mounting tray handle, fully extend the tray from the console.
5. Place the workstation on its side or top to expose the rubber feet on the bottom. Remove the four
(4) rubber feet from the bottom of the workstation using a flat blade screwdriver.
ATTENTION
Installing a blank front panel ensures that the airflow within the console allows proper
cooling of the workstation.
Connecting cables.
- 40 -
Chapter 3 - Installing