Installing Workstation In Lcn Cabinet; Install Workstation In Lcn Cabinet Using Fixed Mount Option - Honeywell T5810XL Planning, Installation And Service Manual

9. Push the side spacers in until the handle is flush with the front flange of the side mounting brackets.
10. Replace both the left and right front retaining brackets. Position the stop peg covered with Vinyl cap
such that it is in contact with the front bezel on the left side and the front bezel handle on the right
side. Tighten the hex threaded standoff to lock each stop peg in place.
11. If an air duct baffle and blank front panel are already installed, go to section,
If an air duct baffle and blank front panel are not installed continue with the next step.
12. Install a 3U high air duct baffle against the console right mounting rail.
3.8

Installing workstation in LCN cabinet

This section provides instructions for installing the Dell Precision T5810XL workstation in a Rittal-based
LCN cabinet (MP-C8LCB1 or MP-C1MCB1). A Honeywell "fixed" rail mounting kit (TP-WPCMF1) or a
"slide" rail mounting kit (TP-WPCMS1) is installed in the Rittal-based LCN cabinet.

Install workstation in LCN cabinet using fixed mount option

l
Install workstation in LCN cabinet using slide mount option
l
3.8.1 Install workstation in LCN cabinet using fixed mount option
1. Remove both the front and rear console doors to access the workstation mounting location.
- 42 -
Chapter 3 - Installing
Connecting cables.