Install Workstation In Lcn Cabinet Using Slide Mount Option - Honeywell T5810XL Planning, Installation And Service Manual

7. Replace both the left and right front retaining brackets. Position the stop peg covered with Vinyl cap
such that it is in contact with the front bezel on the left side and the front bezel handle on the right
side. Tighten the hex threaded standoff to lock each stop peg in place.
8. If you are installing a second workstation in the cabinet, repeat the above steps for the second
workstation, then go to section,
9. Using two hex head screws and two grounding washers, ensure you install a 3U high air duct
baffle against the console right mounting rail.
3.8.2

Install workstation in LCN cabinet using slide mount option

1. Remove both the front and rear console doors to access the workstation mounting location.
2. Place the workstation on its side or top to expose the rubber feet on the bottom. Remove the four
(4) rubber feet from the bottom of the workstation using a flat blade screwdriver.
After removing the rubber feet, the workstation appears as illustrated in the following image.
Connect cables to the workstation.
- 44 -
Chapter 3 - Installing