Installing Workstation In Classic Console; Classic Console Mounting Requirements - Honeywell T5810XL Planning, Installation And Service Manual

11. Start the workstation.
3.7

Installing workstation in Classic console

This section provides instructions for installing a newly purchased Honeywell workstation in a newly
purchased Honeywell Classic console. The workstation is packaged in the manufacturer's OEM
shipping carton and then shipped from the Honeywell factory. This procedure assumes that a new
Classic console is shipped from the Honeywell factory with workstation hardware pre-installed.

Classic console mounting requirements

l
Install workstation in Classic console using the fixed mount option
l
Install workstation in Classic console using slide mount option
l
3.7.1 Classic console mounting requirements
The workstation is installed in the lower mounting location in a horizontal position in the Classic console
using a slide mount or fixed mount option. The following table describes the requirements for these
mounting options.
Option
Slide
Fixed
Requires Maximum
rack workstations
space per console
5U (8.75 1 per
inches) console
4U (7.00 2 per
inches) console
Mounting requirements
Must be mounted on the bottom of console.
The 3U of unused space must have a 3U blank
front panel and air baffle installed
If only one workstation is installed, it must be
mounted in the lower mounting location of the
console. A 4U blank front panel and air duct baffle
is installed in the unused space of the console.
- 36 -
Chapter 3 - Installing